The MJX HYPER GO 43308 RC Car comes with the T3G 2.4GHz transmitter, which features full proportional control, adjustable dual rate and trim functions, lighting control, and a high/low speed switch. Its range is approximately 25 meters.
1. What Transmitter Comes with the MJX HYPER GO 43308 RC Car?
The stock transmitter is the T3G 2.4GHz unit. It uses the 2.4GHz frequency band, which offers better anti-interference performance than older frequencies and doesn't require a long antenna. The transmitter requires 4 x AA 1.5V batteries (not included), so make sure you have them ready before your first run.
2. Which Functions Does the T3G Transmitter Offer?
Despite its compact size, the T3G is surprisingly full-featured for a micro RC car:
-
Proportional throttle and steering: The triggers and steering wheel respond proportionally, allowing precise speed and steering angle control rather than simple on/off switching.
-
Gyro adjustment: The built-in gyro on the MJX HYPER GO 43308 RC Car can be adjusted from 0 to 100% via the transmitter, letting you tune how much stability assistance you want.
-
Dual Rate and Trim: You can adjust the maximum steering/throttle travel (Dual Rate) and fine-tune the neutral point (Trim) to correct any drift.
-
Light control: The linked LED system, including turn signals and brake lights, can be controlled directly from the transmitter.
-
High/Low speed switch: You can toggle between high and low speed modes, which is helpful for indoor driving or beginners.
3. How Do You Set Up and Pair the Transmitter?
The setup process is straightforward:
-
Install 4 AA batteries into the transmitter.
-
Turn on the transmitter first.
-
Turn on the MJX HYPER GO 43308 RC Car. The receiver will automatically bind to the transmitter.
-
Test the steering and throttle; if anything is off-center, use the trim functions to correct it.
If the car doesn't respond, check the transmitter batteries and the vehicle's battery charge, then power-cycle both to re-bind.
4. FAQ
What is the range of the T3G transmitter on the MJX HYPER GO 43308 RC Car?
The range is approximately 25 meters. This is plenty for a 1/43 micro car, which is usually driven in indoor or small outdoor spaces.
Can I use the transmitter to limit speed for beginners?
Yes. The transmitter has a high/low speed switch. Setting it to low speed mode is a good way to help beginners or kids get used to the controls without the car being too fast.
Does the transmitter have a gyro adjustment knob?
Yes. The gyro can be adjusted steplessly from 0 to 100% via the transmitter. Higher settings provide more stability correction; lower settings allow for more free drifting.
5. Conclusion
The T3G 2.4GHz transmitter included with the MJX HYPER GO 43308 RC Car is well-matched to the vehicle. It offers proportional control, gyro adjustment, dual rate, trim, and light control — features that are often missing on micro RC cars. With a 25-meter range and AA battery power, it's simple to use and doesn't feel like a stripped-down toy controller. For the scale, this transmitter is more than capable.