YIKONG YK4084 Parts ball linkage ends 13014
The suspension linkages on the YIKONG YK4084 RC Car use plastic ball ends, part number 13014, at both ends. Once worn, chassis play increases and the car feels "loose." Cheap parts, but replacing them takes patience.
1. Original Configuration
Page 15 of the manual shows ball ends used in multiple places on the front and rear linkage installation. Parts list 13014 is a multi-piece set, while 13052 is the individual linkage ball end. Plastic ball ends wear quickly in muddy conditions and are a typical wear item.
2. How to Tell They Need Replacing
Grab a linkage and shake it—if there's obvious play at the ball end, or there's a fine "tick-tick" sound from the chassis while driving, or you constantly need to correct steering to go straight, check the ball ends. New ball ends are tight and require some force to move by hand; worn ones are sloppy.
3. Replacement Notes
Don't yank the linkage forcefully when removing old ball ends—you can tear the ball end out of the linkage hole. Grip the back of the ball end with needle-nose pliers and twist slowly. Apply a little silicone grease inside the ball cup before installing the new one to slow the next round of wear.
>>>Click here to buy: YIKONG YK4084 Parts ball linkage ends 13014
4. FAQ
Are metal ball ends better?
Metal ball ends are more wear-resistant, but they transmit impact to the linkage and axle housing. Plastic ball ends are cheap and provide cushioning, which isn't necessarily a downside for a crawler.
How often should I check?
Give the linkages on the YIKONG YK4084 RC Car a shake after every mud/water run; address any play when you find it.
5. Conclusion
Replace when play gets bad—a set of 13014 parts isn't expensive. Rinse the chassis after mud runs to make them last longer.