News

Regular maintenance will help extend the life of the Portal Axle Gear 11T & 21T (Part No. 21040) on the YIKONG YK4106/Pro RC Car. After each off-road drive, clean away dirt, sand, and debris from the portal axle and gear teeth to prevent excessive wear. Apply a small amount of grease...

The Differential Lock Mounting (Part No. 21036) is designed to securely hold and support the differential lock mechanism on the YIKONG YK4107 RC Car. It helps keep the components properly aligned and prevents movement caused by vibration or impacts during driving. A properly installed differential lock mounting ensures the differential...

Regular maintenance can help extend the life of the 11T Driving Gear (Part No. 21035) on your YIKONG YK4107Pro RC Car. After driving, especially on dusty or muddy terrain, clean the gear to remove dirt and debris that may increase wear. Apply a small amount of grease to the gear teeth...

Keeping the 34T Driven Gear (Part No. 21033) of the YIKONG YK4107 RC Car in good condition is easy with a little regular maintenance. After each off-road run, clean dirt, sand, and debris from the drivetrain to prevent excessive wear caused by particles getting between the gears. It's also a good idea...

Installation is quick and easy. Align the YK4107 Car Shell Fixing Nut with the body mounting post, then tighten it by hand until the body shell is securely fixed. No special tools are required. Avoid overtightening, as this may damage the body shell or the mounting post. After installation, check...

Start by removing the original C hubs from both sides of the front axle on the YIKONG YK4107 RC Car. Then remove the steering knuckles, bearings, and related hardware. Install the bearings and other components into the new C Hub Set (Part No. 21002) and reassemble them according to the...