The MJX HYPER GO 43308 RC Car uses an independent suspension system, meaning all four wheels move up and down independently rather than being connected by...
The YIKONG YK4061 RC Car Parts Front Lower Rod (26044) can be purchased through authorized YIKONG dealers or the official YIKONG parts website. The YIKONG YK4061 parts category is listed on the official YIKONG forum and website.
If your YIKONG YK4061 RC Car is not holding alignment after a hard impact, the Front and Rear Rod Mounts (26007) may be bent or cracked. This is a common fault on heavy 1/6 scale crawlers . The YK4061 uses a metal frame and metal links , but the rod mounts...
Before installing the new YK8081 13T Spider Gears (80037) in your YK8081, a key precaution is to inspect the sun gears and the differential case for wear or damage as well. The YK8081's drivetrain features steel gear construction, so if one component has worn, others may also need attention . During...
A screeching noise from the motor area of your YK8081 is often caused by a worn or stripped 13T Motor Pinion Gear (80038) . This is a common fault on high-power 1/8 scale trucks running the 2800KV brushless system, especially if the gear mesh is too tight or the pinion has...
To check the YIKONG YK8081 RC Car Parts Drive Cups (80039) , remove the driveshaft and inspect the pin holes for elongation or rounding. Insert the drive pin and check for excessive play. If the pin wobbles significantly or the hole has become oval, the cup needs replacement. This is...
Your YK8081 leaning to one side after installing new Shock Absorbers (80040) usually means the spring preload is not evenly adjusted on both sides. This is a common installation issue. Check that both shocks are filled with the same amount of oil and that the spring collars are set to equal...
The MJX HYPER GO 43308 RC Car uses an independent suspension system, meaning all four wheels move up and down independently rather than being connected by...